![]() ![]() Make sure you use the corresponding plug on your pneumatic tool and that it’s screwed on tightly. The plug, or the male end of the fitting, should be adjusted on the end of your air tool to connect with the female fitting. Take a spanner and wind the fitting until it is tightly put into its spot. The fitting has to be secured tightly or it could end in a number of mishaps, such as air leaks, bursts, or even injury. Now, take the female fitting and screw it onto the male end of the air hose. Step 3 – Adjust the Female Fitting onto the Air Hose End ![]() Even though the fittings are leak proof, it’s good to prevent any possibility of the air escaping through gaps or loose ends. You can use teflon tape, thread tape, or sealant paste on the male end of the air hose to make sure all the gaps are sealed. Step 2 – Use Teflon Tape to Seal the End of the Air Hose This will be shown clearly at the final step. So for this one, there’s going to be a fitting on the hose end, a fitting on the end of the pneumatic tool, and a female fitting between them. Remember – the female end is going to be fitted onto the hose end, whereas the male end is fitted onto the tool. In this case, we are using the Nitto style fitting as shown in the picture above. If you already have a fitting installed, take a good look at it to determine which fitting you will need that will support the pneumatic tool of your choice. Here are the steps to installing an air hose fitting – Step 1 – Select the Correct Hose Fitting Air hose fittings are very simple to install, so you’ll get the hang of it after your first try.įor the following guide, we’ve chosen the Nitto style type as an example. Now that we’re familiar with all the air compressor fittings quick connect and their differences, it’s time to put the info into a practical demonstration. ![]() Standard Cubic Feet of Air Per Minute (SCFM rate) This chart shows the flow size and SCFM of each coupler style – Coupler Style Air hose fittings, or couplers, are measured according to three categories – style, basic flow size, and SCFM rate. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |